Bosch B426 and 3000

[secure]

There is new app update being released in the next week or 2 I believe..... will wait and see...
Also updated panel firmware for Sol 2000/3000 panel.

The app update will fix issues with telstra modems etc and some other minor improvements.

But if you have updated firmware in B426M you probably might of bricked the unit!
Also look at this thread.

[JonAnon]

There is new app update being released in the next week or 2 I believe..... will wait and see...
Also updated panel firmware for Sol 2000/3000 panel.

The app update will fix issues with telstra modems etc and some other minor improvements.

But if you have updated firmware in B426M you probably might of bricked the unit!
Also look at this thread.

Yes, I think mine is now pretty much bricked and have decided not to waste any more time on it.

[milobars]

Experiencing exactly the same issue. I updated the firmware in the hope it would fix my problem where the RSC+ app was not able to connect from outside my network, which meant I could not Arm/Disarm remotely. Now not accepting default password. Anyone having any luck resolving?

Try going to location 0083 and put in 10x zeros. This resets the password in the alarm panel.
Also, in general, don't log into the B426-M via a web browser. Only change programming in the alarm panel itself.