just reprogram it
Hey all.
My goldie was workin fine & got home from work & its stopped..
I can still read it with GGe & all I can see is that its missing the ATR
how do I send / put it back on ??
My other backup is still working , but until it gets an ATR again..
it wont work..
what happened ?? old age !!!
Look Here -> |
just reprogram it
try reprogramming the pic.
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
icprog works with mastera
I have tried some old directions that i found ages ago..
But never had any success with icprog.
it will read the cards, but doesnt seem to do much more than that.
I obviously dont have either the complete directions OR I keep missing a "VITAL" step.
** EDITED**
win98se & com port1
ic-prog 1.05E & Mastera II set @ 3.5mhz (mode 1)
start it up & select PIC 16F84 & read all
then select Smart card Wizard & that all goes sweet
then my problems start...
this is where all the tuts for elvis / jaycar say to swap buttons / switch to ??? & Mastera doesnt have a switch. (change from PIC programmer to smart card programmer)
SO all I do is select the GFG v226 eeprom.hex & continue.
then error messages start
programming not supported or Reseting card failled etc.
Last edited by *fergs*; 15-08-08 at 05:36 PM.
I guess you would have tried re-programming the card at the 6Mhz setting?
Democracy & Ignorance = A Winning Combination
Can some verify that I'm doing the correct steps ???
thanks
Success
Try this, in icprog go settings/option/smartcard and change from 6 to 3.58 mhz
All I need now is a friendly logger to send my HSN and provider ID
What is ATR
I tried the wizard set at 6Mhz and the Jaycar jumper set to 6 Mhz and it ran ok too.
The tutorial said to use jumper set to 3.58.
When I try the card in the STB I get Unknown card. Shouldn’t it be Service scrambled?
Either the it hasn’t encoded correctly or my D-10 MediaStar is incompatible. Any clues?
use ggedit and click the EE Prep button. That should give you a ATR
Last edited by beer4life; 15-12-08 at 11:59 PM. Reason: Can't get image to load properly.
use blackprog
DM500s & Relook 400S Owner.. was now =
copy of ATV Flash for ATV Gen1
WTD : Sniper Elite for Wii - with Rifle if possible
RIP gw1, "LIFE MEMBER" u will be sadly missed
ATR means Answer To Reset.
CMD 21 is sent to the card and an ATR is one of the replies from a 21 CMD.
The word "Answer" should clue you up on what happens when you click on a program that has "Get ATR".
The Answer is 16 bytes or 32 digits (UK based again).
No ATR means no functions on the card work..
Bookmarks