Results 1 to 4 of 4

Thread: How to secure Belkin 54G Modem/Router

  1. #1
    Junior Member
    Join Date
    Feb 2008
    Location
    Brisbane Qld
    Age
    83
    Posts
    73
    Thanks
    4
    Thanked 1 Time in 1 Post
    Rep Power
    199
    Reputation
    15

    Default How to secure Belkin 54G Modem/Router

    Good morning,

    My daughter (about 200km away) has a Belkin 54G Router (model F5D7130) and some cretin in her apartment block has been accessing her network and used all her monthly bandwith. I looked at using Network Magic Pro that uses MAC filtering to lock down the network but it doesn't list this specific router....close but not this one.

    I have picked up the following advice from the net....

    Anyway, in case anybody else is wondering how to secure a Belkin Wireless G Plus Router. You type in the URL into your web browser. On the Wireless section on the left hand side, click on the Security button. There are a few security options here but the simplest is to select WPA and type in a password of your choice. After that, the router will reboot and from then on if any new user wishes to use your network, they will be prompted to enter the password.

    Can anyone offer any further suggestions.

    Thanks

    Neville



Look Here ->
  • #2
    Senior Member
    fandtm666's Avatar
    Join Date
    Jan 2008
    Posts
    5,502
    Thanks
    244
    Thanked 990 Times in 465 Posts
    Rep Power
    1189
    Reputation
    40447

    Default

    she can set the encryption but also use the mac filtering and only allow her mac address to connect

  • #3
    Senior Member
    intelliGEORGE's Avatar
    Join Date
    Jan 2008
    Location
    Sydney, AUSTRALIA
    Age
    43
    Posts
    4,106
    Thanks
    884
    Thanked 1,484 Times in 691 Posts
    Rep Power
    478
    Reputation
    7236

    Default

    Access point configuration

    1. Open a Web Browser
    2. In the address bar type the IP address of your access point.
    Note: By default the IP address is 192.168.2.254
    3. Click on Security in the left hand column under Wireless
    4. Enter your password if any and click Submit
    5. Select WPA-PSK (no server) from the Security Mode section
    6. Enter your Pre-shared Key
    Note: You can mask your Pre-shared Key by selecting Obscure PSK
    7. Click on Apply Changes

    Network adapter configuration

    1. Go to Start and click on Control Panel.
    2. Control Panel window will appear. Double click on Network Connections.
    3. Network Connections window will appear. Right click correct Wireless Network Connection by identifying correct wireless network adapter and click View Available Wireless Networks.
    4. Wireless Network Connection window will appear. Select the network you wish to connect and click Connect.
    5. The should now be security-enabled.
    6. Enter the WPA-PSK network key you set up in the router as above.
    7. If all goes well, you will connect to wireless network at last.

  • #4
    Member
    Join Date
    Jan 2008
    Posts
    255
    Thanks
    228
    Thanked 59 Times in 31 Posts
    Rep Power
    223
    Reputation
    860

    Default

    I found this info very helpful as this was happening to me,Ive blocked the persons MAC address but I wondered if I could use this info in reverse,a sceen dump perhaps to mention my internet is not for sharing.

  • Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •