use google ????? heaps there
Good afternoon everyone,
Just Started playing with a Bosch communication module which is a piece of art : B426
And after some time working on the right configuration scheme, we were able to fully install all the components in the D9412GV4 and we were able to make it works with no problem... UNTIL we decide to delete our only register in the RPS, and remake it from the start.... Suddenly we lost our communication, our memory and everything related to the communication protocol between the B426 Board as for the Computer (RPS Software).
Can anyone help me to discover why the board is not being able to be set up the static on both sides?
Look Here -> |
use google ????? heaps there
Hello Herlei, did you ever get this back to working?
I have the same setup. D9412GV4 and the B426
I can connect to the panel using the RPS software with a static IP and I can connect to the D6600 receiver using the D6200 software I just can't get the panel to talk to the receiver
Last edited by cmgaskins; 15-10-19 at 03:58 AM.
Bookmarks