Hi Leroy could you possibly please repost link to the panda1 file the one with no clean which loads the file unconditionally . I have a pl1 which has no ATR which I would like to get working if possible please.
I tried the link further down in the post but link is not working
thankyou in advance
Last edited by mcmuzzy; 07-12-14 at 12:56 PM.
mcmuzzy (08-12-14)
thankyou Leroy
appreciate it
just tried panda1 on pl1 with no ATR still no luck it keeps coming up no atr and does not load bin . Any other ideas on how to fix this guys.
Are you trying to load a bin file?
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
Yes I am trying to load a pl1 file to try and get ATR back. When I press open select file I want then press Load it comes back with no ATR. The file does not even start writing .
I check it in gup and it says "No ATR form card"
are your comm settings correct ?
yes they are an using com port 1 with mastera V programmer RS232 connection on lappy and have tried both 3.5 and 6 Mhz .
I have tried those ATR fixer programs with no luck at all as well.
Is there a script I can use to fix the ATR anything like that by any chance .
tried switching between phoenix and smartmouse modes ?
should be phoenix mode
Leroy
XCRUISER HDSR600HD twin sat and terrestrial receiver $OOS *
XCRUISER HDSR385 Avant - sold out$OOS UltraPlus DVB-T and DVB-S2 tuners $49 Remotes $OOS
it is in phoenix mode it says 3.5mhz phoenix and 6mhz phoenix
my Mastera V has the following modes on it which are
U - Usb mode
0 - Phoenix 3.5
1 - Phoenix 6
2 - Ludi JDM Pic
3 - Ludi JDM Eeprom
4 - Jupiter Atmel
5 - Jupiter Eeprom
6 - Phone GSM
and then you have the other replicator modes which are for Gold Silver Jupiter and Fun
L - Load
P - Copy Protected
C - Copy (not protected)
could the card just be completely gone or is there still some hope
Bookmarks